Has anyone off of the BMR group purchase installed their lower arms and rear sway bars yet?

I installed my lower arms a couple weeks ago- and Just ordered the 1" rear-sway bar from them today- Just wondering if I will need shims- or if it will line up properly with their arms...

I am wondernig this also... My entire set of arms/swaybar are still sitting here on the livingroom floor, but now I wonder if I'll need shims for the bar... I'm waiting on some 11" rear drums before I disassemble and reassemble everything~ Am also getting QA1 shocks for the rear along with that support bracket that beefs up the mount points. :eek:

Just as an FYI, when I did the BMR set in my 71, I re-used the stock 3/4" sway bar I already had. I did not have to shim it... in fact, the BMR arms are thicker than the stock ones, so I had a little trouble getting the sway bar in because it was too tight! Nothing a little sweat and a size 11 boot could not 'persuade' in!

Best of luck, you're going to really like the new setup!

Bill C.