Can a set of 1980 Trans am spindles be made to fit my 66 chevelle? if so how? and is it worth it? I have the complete brake setup from the T/A along with the rear disks. Trying to keep it low budget. Thanks
-Bill graemlins/clonk.gif

Bill,

The spindles from the Firebird would be the Tall Spindles that gets allot of attention around here. If you search here you will get a TON of reading on the Tall Spindle swap. The best description on what needs to be done to use them is here. (http://www.globalwest.net/1964-72%20disc_brake_conversion_informatio.htm) You will need a new lower ball joint, outer tie rod end, and an aftermarket upper control arm.

Checkout my webpage, it is not a complete Tall Spindle swap, but you can get some ideas.

Good Luck.