2004r tail shaft bushing replacement [Archive] - Chevelle Tech

: 2004r tail shaft bushing replacement


sambooka
May 4th, 09, 9:34 PM
1964 Chevelle with 2004r
I am in the process of swappping the stock driveshaft for an Aluminum one. In the process, I noticed that the tailshaft busshing had gone bad (witness marks on the yoke). Since the 2004r trans does not have a removal tail housing, I need some advice on how to remove/reinstall a new bushing (never done one before). Is there a special tool for doing this? Thank you for any advice you can give.

Motorvation
May 4th, 09, 11:44 PM
sam....There is a special tool for removing the bushing with trans in the car. Also to install. Know a tranny guy to borrow it from?

Steve O.

sambooka
May 5th, 09, 12:09 AM
Do you know if the tool is only for the 2004r or is it for all the GM transmissions? thanks for the reply.

72blownvert
May 5th, 09, 3:02 PM
that tool also works on 350/700r4/200c they all take the same bushing.

LeoP
May 5th, 09, 6:44 PM
I have the tool, PM me if you want to use it.

plcguru
May 5th, 09, 8:47 PM
Get this for $20 (http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=170279814950) . It's a steal(everywhere else its $130+) and a nice tool... plus you can resell it when you're done with it for what you paid and the next guy will get a good deal to :thumbsup: (I kept mine though)

sambooka
May 10th, 09, 9:58 PM
You guys are the best. thanks so much for your help. Ordered one off of ebay tonight.