Hello,

I am almost ready to order 2 full quarters, outer wheel well on drivers side, and the piece that goes between back window and trunk. Are any of the sheet metal vendors out there better fitting than others? I have heard that the replacement panels will not align perfect. Any suggestions are appreciated.

Derek
1972 chevelle

Most of the suppliers sell the same Goodmark brand. Look for the best deal including shipping.

I just got some qtrs for my 66 from Matt's Bowtie in Concord CA - about 35 miles from you in Vacaville. I drove from the San Jose area to Matt's to pick them up to save on the shipping charges. I've ordered other stuff from Matt in the past too. They are about to move to Dublin CA though, closer for me, but a little further for you.
http://www.mattsclassicbowties.com/

I've also been to Jim Dyer's in Stockton, but that's a bit further for you
http://www.jimdyerchevyclassics.com/

I just got some qtrs for my 66 from Matt's Bowtie in Concord CA - about 35 miles from you in Vacaville. I drove from the San Jose area to Matt's to pick them up to save on the shipping charges. I've ordered other stuff from Matt in the past too. They are about to move to Dublin CA though, closer for me, but a little further for you.
http://www.mattsclassicbowties.com/

I've also been to Jim Dyer's in Stockton, but that's a bit further for you
http://www.jimdyerchevyclassics.com/


Thanks for the info, I didn't know of any local vendors. I would drive to Dublin if needed. I'll check them out.

I'm not sure when their moving, but here's their addresses

Currently at:
1381 Franquette Ave C4
Concord, CA. 94520

Moving to:
7114 Village Parkway
Dublin CA 94568


Same phone:
925-676-7172