how to wire up the starter [Archive] - Chevelle Tech

: how to wire up the starter


KarlJay
Mar 5th, 09, 12:45 AM
I've found the wires to start the engine, now I need to mount the starter.

I've got three wires on the top and three on the sol

1 large 2 small on top of starter (labeled R and S)
2 large 1 small on the sol

the large on starter is battery
I'm guessing the small on sol is for wire from ign sw to activate the starter

the small on starter labeled S has a wire going to 1 large on sol

So what goes where???

Thanks, KarlJay

8587camaro
Mar 5th, 09, 3:33 AM
the three large go on the solenoid where the positive bat cable goes the small on the sol goes to opposite end of the sol on the bottom are you sure that all of those wires are used because i doubt you have that many one of them is probably the choke or tach wire

onovakind67
Mar 5th, 09, 7:23 AM
I've found the wires to start the engine, now I need to mount the starter.

I've got three wires on the top and three on the sol

1 large 2 small on top of starter (labeled R and S)
2 large 1 small on the sol

the large on starter is battery
I'm guessing the small on sol is for wire from ign sw to activate the starter

the small on starter labeled S has a wire going to 1 large on sol

So what goes where???

Thanks, KarlJay

Is this a stock starter on a stock car?

68KMENO
Mar 5th, 09, 10:16 AM
one is the B+ battery wire ......large RED
one is the starter wire to tiger the sol ...Med purple "s" terminal on starter
one is the power to the points to supply power while cranking ...small yellow " I "terminal on starter