Where do I get these and what are they called? I have a replacement rear windshield to trunk filler panel and they didn't put these in, so now I have the job of pulling the windshield back out and installing these.

I'm referring to the little studs that attach anything from the vinyl top molding clips to the WS reveal molding, I know I've seen ones that screw in.

Usually the little sheet metal screws come with new clips.

I've got what you're looking for from these people; http://www.auveco.com/index.htm I don't know if they still make them but a phone call will answer your question.

#4 x 1/2" stud replacement screws. They have a small area before the head that doesn't have screw threads. PM me with your address, as I have extras. When I bought some I could only get them in a box of 100.... like I'll ever use em all.

Thanks a bunch Dave!!

I got mine the same way, a friend bought a box of 100. As if!

I had both quarter panels and the filler panel replaced on my '69 SS396. Is there a specific spacing required between these studs? I looked at the rust marks behind the trim and it appears that they were closer together on the lower part than the upper half that is still intact. What size drill bit should be used and how do you seal these things up to prevent leaks? Thanks for any info.

http://www.opgi.com/product.asp?ProdCode=CH2201&topcatid=18&grpcode=12273&yearrange=&chapterid=18&topvalue=0&newflag=0

i think theres less than 100 in this kit if it helps anyone