What type of adhesive do you use to attach the replacement brushed aluminum inserts on an automatic floor shift console? Also, where can it be purchased? I have read thru many of the posts and cannot find the answer. I would also be interested in any tips and tricks that others have used to obtain good results. Thanks.

Brad, I used contact cement. It works great. You can buy it from your local hardware store.

Mike

Brad,I used 3M weatherstrip adhesive.A few dots in the corners and sides and the same on the console in the same areas,let it tack up and apply.:p

I used 3M plastic emblem &trim adhesive, worked like a champ. Use a thin layer on the top plates and make sure none squirts out the side an you will be set.

Thanks for all the response. I ended up using the contact cement and that worked well. The after-market brushed aluminum inserts had to be trimmed slightly to fit the console castings, but the job ended up looking great. I used a dremel tool to make the modifications.