Hey guys, looking for some approx values on some of this stuff. Looking to unload this stuff eventually. Thanks!

1. Forged 2680 Casting SBC Small Journal Crank. Ran great when pulled, the throws and journals are smooth, cross drilled. It is also a .020 on both the rods and mains.

http://i65.photobucket.com/albums/h213/stikman33/IMG_1519.jpg

http://i65.photobucket.com/albums/h213/stikman33/IMG_1520.jpg

2. SBC Rods attached to Keith Black Silvolite 1423 .060 over pistons, with caps and nuts, etc.

http://i65.photobucket.com/albums/h213/stikman33/IMG_1526.jpg

http://i65.photobucket.com/albums/h213/stikman33/IMG_1524.jpg

3. Edelbrock 1405 Performer RPM 600cfm carb with Electric Choke added. Running great when pulled, ready to run.

http://i65.photobucket.com/albums/h213/stikman33/IMG_1514.jpg

http://i65.photobucket.com/albums/h213/stikman33/IMG_1513.jpg

Thanks for any info!

-Daniel

Not much help here, but I have always been told 50% off of new cost for used items.

It will probably be hard to sell because of the cheapness of stroker kits for small blocks. Good luck.

Thanks for the input, so a new crank goes for somewhere around 5-600 dollars it seems. I'm not going to use this stuff, so something is better than nothing even if it isn't a ton. Finishing up the BBC build and needed a little cash to complete it.

-Daniel