|
: Help, how do I get the Ignition Lock out! rlhelton Oct 9th, 99, 6:54 PM Hello everbody, I'm disassembling a column I picked up from a 72, it's non-tilt, but I can't figure out how to release the ignition lock. How do I do it? ------------------ Rick 72 Malibu 98 Fatboy Team Chevelle Member #369 DZAUTO Oct 9th, 99, 8:33 PM This one is tough to explain. First, everything above the ignition switch has to come off. There is a tiny slot for inserting a fine small blade screwdriver into at the backside (?) of the switch to depress a little tab which releases the switch. Sometimes on columns that have never had the switch removed, this slot is solid and must be broken open first. I can show you in a heartbeat, but it is hard to explain. Can some one explain it better for us? ------------------ Tom Parsons rlhelton Oct 9th, 99, 8:35 PM Thanks DZ, I finally got it, I was at the right spot, though I couldn't tell. The cylinder was just stuck though. And your right, it would be hard to desribe exactly where you have to break through. Luckily mine was slightly open to begin with, so I started opening that slot up. mr409 Oct 10th, 99, 6:24 AM First time I heard of a "Virgin" steering column. I'll be doing this same job soon. Thanks for not only answering my question, but also asking it! ------------------ Bob (Pa.) 1963 Impala 283 1966 Chevelle SS 409 1969 Malibu 307 1972 Malibu 307 1969 Chevy stepside 350 Bob's 409 Chevy Page silverstone.fortunecity.com/tvr/246/bob_s_409_chevy_page_index.html (http://silverstone.fortunecity.com/tvr/246/bob_s_409_chevy_page_index.html) Dean Oct 10th, 99, 8:33 AM check out the archives http://www.chevelles.com/archive I think we did have a picture that Gene McGill put up but it seems to be gone now ?? http://www.chevelles.com/archive/files/69ignrem.htm ------------------ Dean Call Overland Park KS Team Gold member #3 A.C.E.S. # 00235 N.C.O.A. # 4350 macc.chevelles.net (http://macc.chevelles.net) Gene McGill Oct 10th, 99, 9:06 AM The picture is still available at http://personal.riverusers.com/~mcphelps/latch1.jpg rlhelton Oct 10th, 99, 9:11 AM Thanks Dean, I saw the archive, but without a pic, it was hard to figure out. Especially since the lock was tight, I wasn't sure I was at the right place, I could feel the tab push in but the lock still wouldn't release. It was just stuck. With a little careful prying it finally came out. The whole column is now apart and soaking in parts cleaner. I'll paint it up tonight and reassemble it tomorrow. P.S. Thanks Gene. You posted while I was composing this one http://www.chevelles.com/forum/smile.gif [This message has been edited by rlhelton (edited 10-10-99).] Dean Oct 10th, 99, 2:34 PM Guess I never did put your picture up Gene, I remember I was trying to figure out how to put a picture in the archives cause we never did it before. It's there now though, hope I did it right OK Al ? http://www.chevelles.com/forum/smile.gif ------------------ Dean Call Overland Park KS Team Gold member #3 A.C.E.S. # 00235 N.C.O.A. # 4350 macc.chevelles.net (http://macc.chevelles.net) | ||