Changing from console automatic to console 4 speed in a 68 SS need to know were to weld in the 4 speed hump, motor and trans are out of the car, need some kind of mesurement location.
Thanks

This is a 69 chevelle 4speed, I don't think it had a console in it, but it might help. http://www.1969supersport.com/hump.html

Rob

Changing from console automatic to console 4 speed in a 68 SS need to know were to weld in the 4 speed hump, motor and trans are out of the car, need some kind of mesurement location.
Thanks

I would wait until you have the trans in just to make sure its perfect. Going to be difficult to measure and get it right IMO.

I would wait until you have the trans in just to make sure its perfect. Going to be difficult to measure and get it right IMO.

imho, this is the ONLY way to get it right.

A fellow TC'er emailed me these measurements I used on the 4 speed hump w/console for my 68. They worked perfectly for me...

I created a line between the seat belt bolt holes over the tunnel, and then measured from that line to the hump opening. This measurement is 24 1/8".
I also measured from the console brace to the opening which is 16". I measured from the outside edge of the door sill to the edge of the opening. On the drivers side it is 31 5/16", on the passenger side it is 31 7/8" so apparently the hump opening is biased towards the drivers side.