|
Tru70SS/RS Nov 13th, 08, 10:02 PM im assembling my front suspension on my 70 wagon. the only piece i cant ID are these snubbers. the lower control arms have rectangular shaped bump stops but where do these go? THANKS http://usera.ImageCave.com/Tru70SSRS-RS/MVC-008F.JPG dyno jonn Nov 13th, 08, 10:41 PM They pop into a hole in the upper a-arm and hit a spot on the frame when the car lifts that high. gene_sc Nov 14th, 08, 1:02 AM On a 71 coupe I'm working on it pops into the frame below the upper control arm (above the spring pocket) dyno jonn Nov 14th, 08, 12:38 PM That could be. I was thinking about the Camaro I'm working on now. :clonk: gene_sc Nov 14th, 08, 1:09 PM That could be. I was thinking about the Camaro I'm working on now. :clonk: lol I do camaros mostly, so I had to double check the chevelle I'm working on.... Rich-L79 Nov 14th, 08, 1:46 PM There should be a hole in the frame below the upper control arm as mentioned above. In this photo you can see the spot in question easily since I have tubular upper arms. The spot is the round spot directly inboard of the ball joint. I've installed small black plastic plugs in this hole to give the chassis a more finished look. http://heartland.chevelles.net/RCstorage/wagon/frontsusp/frontsusptopdown.jpg Tru70SS/RS Nov 14th, 08, 7:27 PM alright guys found it thanks ! | ||