Hello all ,
I need some direction on where to go to fix this. I am not getting any spark at my plugs. I have replaced the coil , the pick up coil, and the cap. Still getting no spark its a HEI distributor. the module tested fine too. Any other ideas? I ran oHm's on almost everything and it seems to all check up.

Any ideas where to go next?

I would look to see that you are are getting systems volts to the dizzy while cranking.test the feed wire at key on for 12 volts and then while cranking.Obviously..the cranking volts will be less than key on only..but should be over 10 volts.

The button under the col is in place?

I have seen this happen in the past, check the wire going to the pickup coil and the module, I have seem them deteriorate and cause the exact symptoms you are describing.

Everything you're likely to need is right here:

http://www.chevelles.com/techref/ftecref5.html