Hey Guys, couldnt think of where to post this so here it goes, I am trying to figure out what this thing is called so I can find one and order it, any help would be appreciated, its a Y-Pipe that you place between the headers and the mufflers on each side, and it splits and flows one way into the muffler, and the other way makes it straight pipes, I found one, but it required that you take off a cap on the outside of your car. I was told that they sell one with thing that you pull inside of your car and it opens and closes each side of the pipe, anyone know what this is called???

You can find those in JCWhitney, but the ones ive seen were poor quality,didnt seal well, and were only made for small tubing. Youre better off with the ones you have to uncap, or the electric cut-outs that are on the martket now, IMO.

Exuast cutouts , They sell them in Jegs Page 14 has the cap offs you are refering too. They have the wire pull ones as well . Hope this helps .

Thanks guys, exactly what I needed!

I recommend the ones that have 3 wing nuts holding them on. You'll be sorry with the electric or cable cutouts...until I upgraded to 3" exhaust I had the cutouts with wingnuts on them...worked great and sealed good,always...now they are on my sons truck,still doing the job.

Same ones I have:

http://members.cox.net/zr2much/Image239%20web.jpg

CID is that a 5 or 6 speed I see? :D

Tremec 5 speed....can't wait to try it out! Should have the front clip on this weekend.