Hey guys, My question is for the clutch lever assembly which connects to the bell housing and the frame. The bracket that connects to the frame, does it share the same holes where the brake line bracket is mounted to on the frame or do the 4 speed cars not have this bracket? The assembly manual only shows the one bracket that I have found so far. Again I got this car in boxes so I have nothing to go by since I didn't take it apart. Looks like I also need to change the starter nose since I started with a automatic set up.
Ray

I'm also interested in the bracket location, i'm currently putting a tremec in, in place of a700r4. I have everything but the linkage and not sure of the connections. If you find out i'd be interested

I believe that your clutch pivot is in the wrong location, it should be on the block upper right of oil sending unit. The clutch pivot frame bracket is mounted in the general location of you brake line bracket, the Manual does not show the brake bracket when using a clutch. Here is a pic of that area. Hope this helps.

I believe that your clutch pivot is in the wrong location, it should be on the block upper right of oil sending unit. The clutch pivot frame bracket is mounted in the general location of you brake line bracket, the Manual does not show the brake bracket when using a clutch. Here is a pic of that area. Hope this helps.

Alan, you are correct, since taking that picture I notice it should be mounted to the engine. When I got the bell housing that was where it was mounted. Thanks
Ray