Ok so I installed my new disc brake conversion kit on my 72 Chevelle Malibu and after removing the factory valve on the frame rail I am trying to bleed the system and can bleed the front with no problem but the rears just don't seem to bleed. I don't know what I am doing wrong. Please Help!!
-Scott
6086287410

:confused::confused::confused::confused::confused: :confused:

i have the same problem did you ever figure out what was wrong?
thanks dave

Scott/Dave - Is it a 4 wheel disc, or front disc rear drums?

its front disc, rear drum...i just got in from working on it and just so frustrated... did you figure yours out?

I just finished my conversion with all new dry lines. I used a Mityvac bleed tool to get the fluid from the master to each of the wheels, starting from the furthest to the closest. Once I knew I had fluid to the wheel I bled them the old fashion way with a buddy pumping and me under the car....seemed to work okay for me. The pedal is good and firm. The tool is only about $30 and seemed to save me some trouble.

where did you get the mityvac tool to bleed your brakes?

I've had mine for a while, but you can find them on ebay

http://cgi.ebay.com/ebaymotors/Mityvac-6820-Brake-BLEEDING-Kit_W0QQcmdZViewItemQQcategoryZ35625QQihZ008QQitem Z180288696196QQrdZ1QQsspagenameZWDVW