|
tionestat Aug 19th, 08, 5:17 PM Guys, I have seen the conversion discussed but the conversion is with a 4 piece bracket set up -- one long bracket for the inward side of the seats and one small bracket for the front outer corner for each seat -- I just picked up a conversion from NPD that has only two brackets -- the inner long ones, is this going to work OK Thanks 1966_L78 Aug 19th, 08, 7:52 PM it will work, but the seat won't sit exactly right... I had a Chevelle with a kit like this, and I never noticed the difference... The 4-piece kit actually raises the front-outer mount about 1/2"... Thats the big difference... I bought the 4-piece kit from Hinshaws. I think it was actually less expensive than the other guy's 2-piece kits... Bryan59EC Aug 19th, 08, 11:55 PM Also----if you have seatbelt retractors, the seat will be up tight against them. 64chevlle Aug 20th, 08, 5:03 PM not to hi jack your thread but do you still have your bench tionestat I might be intrested..] tionestat Aug 21st, 08, 8:34 AM no bench seat it came with about 25 holes in the floor and early 80's camaro buckets - they are for sale and i have a nice set of 64,65 chevele/GM buckets 64chevlle Aug 21st, 08, 10:37 PM I'll pass on the buckets at this time, I am going for the elusive bench seat granny look...lol | ||