Well I just put some new valve covers on and switched from a double breather setup to a pcv valve and one breather. I just wanted to make sure that the change will provide adequate air circulation for the engine. Basically what I have is....

drivers side valve cover has a big k&n breather
passengers side has a pcv valve in the valve cover with hose running to the middle vacuum port on the carb (edelbrock 1406). Did I run the line to the correct port on the carb? It's the large one that's inbetween the two smaller ones that are for vacuum advance and another vacuum line. Just want to make sure it's all set up right, so i don't blow any gaskets or anything. :D

Thanks a bunch
-Ben

You got it. Should work fine.

Good to know...thanks.