I am replacing the coil spring mounts on my 12 bolt with ones needed for an air bag system to get the right ride hieght. I removed the rear end and leveled it on the bench so that when I remove the old mounts I can install the new and reference them to level. What I found while leveling the rear end was that the brake baking plates were square to the tubes but the pumpkin acually droops. From baking plate to baking plate the pumpkin is lower. I wanted to find out if that was a problem and also see if there is a correct way to reference to coil spring mounts as far as level goes.

Thanks

Donn

Uh,oh.