Hi guys. I keep flip-flopping on what I want to do with my motor build. I found decent deals on all the parts, but I would like the comments of others. If you got time, can you give me your advice? I would appreciate it.

Mark V 502 block
JE 9:1 forged pistons
GM 4340 Dimple Rods
Factory 502 crank
049's ported and polished; 2.19/1.88 Milled to 110cc chambers.
Compression ratio should be around ~9.5-10:1 (correct me if I am wrong)
Comp Magnum 305h (11-214-4)(Thinking I need more compression for that cam though)
E-Brock RPM Air gap
Holley 950 mech secondary (maybe 1050, or is that too big?)
M-21 4 Speed
3.73's 12 bolt posi.

Should make for a nice street car. So what do you guys think?
Chris

That will make for a VERY nice street car. With that many cubic inches, that cam will run just fine. With a standard trans, idle quality isn't that big an issue. graemlins/thumbsup.gif