Is anybody running slicks on late model(78-87) Malibu? I am running 28x9x15 Hoosiers now but the 468 inch big block could use something wider. Any ideas on tire size and wheel width and offset would be appreciated.

Thanks,

Ohhhtom

A buddy has an 80 Cutless (SBC powered) and the largest he can fit is 28/9-15. Another buddy has a 78 or 79 Malibu. With a notched frame I think he is using 30/10-15 but I'm not sure about that. The real issue is section width. I think a Hoosier has a narrower section width for the same tread as a M/T.

I have a 78 Malibu I run a 71 12 bolt it is 3" wider. My wheels have a 1.5" offset to compensate for the rear end. The slicks I run are 28x10.5/15 MT ET Drags. I had to notch the rear fram rail and weld in a piece of steel for support.
John

Originally posted by ohhhtom:
Is anybody running slicks on late model(78-87) Malibu? I am running 28x9x15 Hoosiers now but the 468 inch big block could use something wider. Any ideas on tire size and wheel width and offset would be appreciated.

Thanks,

Ohhhtom Go here...

http://www.maliburacing.com

There's a good tech/faq section on Phil's site. I wrote a couple articles he hosts on just that subject. He also has a good message board specifically for the Malibu's & A/G bodies.