Houston, TX area bumper plater [Archive] - Chevelle Tech

: Houston, TX area bumper plater


mcmanus2301
Jun 30th, 08, 10:02 PM
I'm am looking for a recommended chrome plater in the Houston, TX area. I need the front and rear bumpers done for my real LS6. I would like to deliver them myself, not ship.

Thanks, Scott

davis95
Jun 30th, 08, 10:10 PM
Not sure about the chromer, but I noticed you're from Westlake. How far is your car from completion?

pglade
Jun 30th, 08, 10:28 PM
I have seen bumpers plated by Superior Bumper (I think that's the name) in Houston and was not impressed at all. I think they just do the chrome/nickel instead of the full blown copper/nickel/chrome triple plate process. In any event, I was not impressed with how the bumpers appeared regardless of the shine, etc...too wavy, etc. Apparently, DalChrome (Dallas Chrome) doesn't triple plate either and it shows in their work.

You could consider or call Speed and Sport. Cost is much higher....recently ran approx $650 or so for a 70 Olds front bumper. Triple plated and they did a nice job. The rear bumper was a similar cost but not as impressive of a job....the 70-72 Olds rear bumpers, however, are shaped such that any imperfection will be very apparent across the top half or so of the bumper (it's a long FLAT area).

Were they better than what I have seen from Tri-City Plating out of Tennessee?? (at a substantially lower cost also) ...in my opinion, NO. At most, the Speed and Spot work may have been equivalent.

You should consider boxing and shipping to Tri-City. The key on the front bumper is to run something STIFF (wood or a steel bar) across the backside of the bumper so it won't flex if dropped on one end or someone jumps on the middle of it during shipping (ask me how I know this:mad:). Also..CLEAR INSTRUCTIONS TO THEM TO DO THE SAME WHEN THEY SHIP IT BACK.

Hopefully, those are some ideas to help get you started.

Moss22
Jul 4th, 08, 1:32 AM
Speed and Sport are the best in town, top quality work, they have been around for years and stand behind their work. Ask for Craig 713-921-0235,they also do UPS C.O.D's.

Alan F
Jul 4th, 08, 2:31 PM
I used A1 about 10 years ago on a set of El Camino bumpers and wasn't impressed.
I had some Malibu bumpers plated by Speed and Sport about 4 years ago and was pleased with the plating. However, I felt the bumper could have been massaged a little more.

I was seriously entertaining sending my next ones to Tri-City.