Whats the best way to go from 1/2" tubeing to a -8 an fitting?


IM thinkin I could just double flare a 1/2" npt fitting on it and use a 1/2" npt female female adpater then a 1/2" npt to -8 adapter.

They make a tube nut that will do this for you. You need a 37 deg flare tool though. Put on the tube nut and ferrule, and flare it with a 37 deg flare, and you can attatch it to any male -8 fitting. You can do it with less adapters this way.

hello i found the russell hard line adaptor to be SUPER easy to install and for the 9 bucks it doesnt leak and it looks great !!!
they come with a female or male end for the AN side
bryan

I just pushed the -8 over the 1/2 inch line and double clamped it,not pretty but no leaks in 9 years.I ran the hard line under the car where you can't se it and the -8 up into the engine compartment.

if your using aluminum line..you dont need the 37º flare tool...just use a normal flare tool ..the tube nut will flatten out the flare enuff

the russell hard line adaptor works great, very easy to use nice and clean

Tunedup , Best way to got from tube to AN.Go to adapter fittings and aluminum fuel line and adapters.

http://www.russellperformance.com/automotive/index.html