The holes are rough, and i started small figuring i can make them larger later, but i don't really know if i need to or not, i went roughly 1/2 inch smaller than the cardboard cutout from the original floor lining, and the trans seemed to sit in the hole nicely, so before i begin cleaning it up and tacking in my non-console hump from opg i wanted to see what everyone else thought. Thanks- Mike

http://thumb1.webshots.net/t/66/666/7/28/87/2057728870093174441YrOgoG_th.jpg (http://good-times.webshots.com/photo/2057728870093174441YrOgoG)

http://thumb1.webshots.net/t/66/666/0/32/98/2529032980093174441kOawod_th.jpg (http://good-times.webshots.com/photo/2529032980093174441kOawod)

That looks great, Mike. How do you plan to seal the floor to the OPG hump, seam seal it from below?

Thanks Wayne :D yeah i have to put in a new pass side floor board in the front so i'll seam seal it all up before i put some undercoating on it