Looking for information regarding insullation of bucket seat end cap kit. It appears they need to be cripped on but not sure. Any information is appreciated.

Thanks

rembow:waving:

If your talking about the round chrome caps ....you just lightly tap them on the shaft with a rubber mallet

Mine didn't just tap on... They needed to be slightly crimped. First, I used a needle nose pliers to crimp each side backwards a bit. Then placed the caps in the correct place and use larger plier (that was wrapped with paper towel & some tape to prevent scratching) to crimp then in place.

Good luck.

I had to crimp my end caps as well with needle nose.