OK I have the angle plug heads with 5/8 plugs x 3/4 inch thread plus headers.
I need to build a wrench or socket too get these plugs tightened and untightened. A reg 5/8 socket don't fit at all. A wrench (box end) don't fit.

I'm taking a old wrench and socket to work today. And will grind it down as much as I can. I would like to see how others have solved this problem...Thanks..

http://www.headersockets.com/

For what it's worth, I ground one down and it worked like a charm.

If this is the passenger side rear plug with headers (and you have A/C), I bought a "45 degree deep offset box end wrench" just for that for ~$15. (I only bought one, standard finish, the picture is what it looks like.

http://s7.sears.com/is/image/Sears/00944071000?qlt=90,0&resMode=sharp&op_usm=0.9,0.5,0,0

I took a 5/8" combination wench and ground one end down where it would clear the head bolts. Works like a charm.

I bought the sockets shown by Yelcamino...........what a pain otherwise!

Snap on has a socket for that.

http://www.headersockets.com/

...I made one at work today...same as the link above...
And ground down a 5/8 box end wrench...
Should do the trick..
Thanks guys...

http://www.headersockets.com/

:yes: I've got the set...works great!! :thumbsup: