|
blumont Nov 18th, 03, 8:52 AM My UD 276H10 is 110 LSA and 104 ICL. Does this mean when I install it I should be installing at the +4 keyway on the crank gear and then degree from there? I have assumed that there is supposed to be 6 degrees ground into the cam and I should install straight up and degree from there. Degreeing then verifies that the 6 degrees was groundinto the cam. Right? Thanks Jerry ImpBiscuit Nov 18th, 03, 9:25 AM On all of the Ultradyne cams I have installed the advance is not ground into the cam. You need to drill the cam gear and install degree bushings. Put the crank gear on zero. Then check with wheel. John Pat Kelley Nov 18th, 03, 5:32 PM Harold mentioned a couple times that he puts 2º in the cam so the 4º keyway will give 6º. I don't know if this applies to all UD cams. blumont Nov 18th, 03, 5:41 PM Thanks, I actually sent Mr. Brookshire a fax this morning. Hopefully he has a spare minute sometime soon to respond. Jerry | ||