Hi i am building a 383 for a friend so far we have planned(already have bottom end)
SRP flat tops
We plan on using 195CC trickflow aluminum heads
AIr gap intake
750 double pumper
1 5/8 headers
around 3000 stall
compression will be right aroud 10.7-1 but havent totally computed it yet
zero deck
possibly 1.6 rockers
I need a decent cam to help bleed off some of the compression but don't want a monster no vacuum cam, this car is mostly street. it is a 78 camaro that probably weighs about 3600 ibls. i was looking at these cams off the lunati website, but wasn't sure if they were up to date with your new desings
Solid Strong cam for 355 Pro Street car, 2500 SS converter, 600 or better Holley, headers and 3.55 gear. Power 2500 to 6800. 276 284 243 251 0.518 0.530 0.345 0.353 110 104 17° BTDC 46° ABDC 60° BBDC 11° ATDC 401A6LUN UF9 UF8 01-UF9-UF8-10-A01

and this cam;

Solid For 4412 500-CFM 2 BBL with cast iron intake/exhaust. Power 2500 to 6500. 275 279 247 251 0.530 0.540 0.353 0.36 108 102 21° BTDC 46° ABDC 59° BBDC 12° ATDC 401A4LUN TF72 TF73 01-TF72-TF73-08-A01
Let me know what you think i will probably call you tomorrow. thanks!

TTT

we used a Lunati/ultradyne 276/284 solid flat tappet. engine is going in the car this week.