Just need to know what size or part number in engery, for the front end link polyurethanes. Can I get away with using different sizes? I lost 1 end link, talk about crappy ;)

Found it :D

9.8118 is what I came up with. I used PN 9.8105 to replace just the rubber grommets to poly urethanes on my good endlinks. I also used PN 9.5164 for greasable poly urethane sway bar bushings for my 1 1/8 TA/Z28 junkyard bar.

For 45 bucks all together (junkyard entrance fee, sway bar, greasable poly swaybar bushings, poly end link grommets) and some wrenching+elbow grease, it's probably the best thing I've done for the car since the front suspension rebuild and align (rubber rebuild). Curves and turns are much more fun now. The bar and bar bushings did wonders on downhill and flat curves, but the endlink grommets really made hard turning at lot more fun.