Does anyone know who makes a replacement for the metal support structure that supports the package tray? Im looking for the metal shelf that the rear speakers mount to. Thanks in advance. Oh by the way it's a 70 Chevelle.

Yours wouldn't happen to look as bad as mine now would it?
http://i11.photobucket.com/albums/a187/swartlkk/1970%20Chevelle%20Resto/th_Chevelle_7_7_07_06.jpg (http://i11.photobucket.com/albums/a187/swartlkk/1970%20Chevelle%20Resto/Chevelle_7_7_07_06.jpg)

I'm looking for the same info...

Bull and Kyle,
Unfortunately no one makes the tray or the seat divider, I know I needed both. I had to buy from a donor vehicle in the junkyard. It was really in good shape but still had a few holes in it. I suggest you check around. They are available but not so easy to find. If you have a plasma cutter you can make your own. Also this is a tough piece to remove and re-install.
Roland in NY

Well...that would figure. Mine looks exactly like the one in the pic, or maybe worse.

I'm just glad mine only looks like that on the passenger side!!

The race is on! Which one of us will find one first!! LMAO!!!

That piece does not look that hard to make out of sheet metal.

I'm going to give fabbing one a shot.....this should get entertaining.

Just saw in Ground Up (a sponsor to boot!) has that piece including the rear seat dividing panel available in reproduction. I have the same problem with mine. Hope this helps.

Hi,
That piece from Ground Up looks good but I only need the top part. Hopefully they will sell it in separate pieces eventually.
Rick

I got mine from a boneyard on Oklahoma. It wasn't cheap but did the trick. My bodyman says it wasn't too hard to install either.