Upon installing new bushings in my lower control arms, I noticed that on two of the bushings the rubber and center metal sleeve can slide out off the outer metal sleeve, they are still tight they can slide out with a little work. I used the install/removal tool on this site and braced the control arms so they wouldn't collaspe during the install. I am thinking the side to side movement will be controlled by the bolts and brackets when they are installed. Is this correct thinking or do I need to start over with new bushings?
thanks

The bushings are fine. :thumbsup:
The metal sleeves aren't going anywhere after the LCA is installed.

thank you , I thought so and was hoping so:thumbsup::thumbsup: