Anyone know any tips or tricks to remove a dent from the outer bevel of an aluminum ultra lite tach?

Assuming there is no way to remove these stubborn dents, does anyone know if you can buy just a replacement aluminum bevel?

thanks.

http://s205.photobucket.com/albums/bb125/smithd6178/cars/?action=view&current=CIMG9094.jpg

http://s205.photobucket.com/albums/bb125/smithd6178/cars/?action=view&current=CIMG9096.jpg

just in case anyone was wondering, you can send the tach to autometer and they will replace the bevel for 25 bucks plus shipping. I guess they dont sell the bevels by themselves.

Classic Instruments are constructed so that the outside bezel ring is crimped over the guage and cup to insure a tight fit. Autometer units may be constructed the same way.

blksheep...in Charlotte