|
: old pistons and rods to new...same block? 300hp Mar 7th, 04, 10:23 PM i want to get some forged pistons and better rods to put in the 355 but do i need to rebore? its a .030 over 350 w/ fed mogul 9.35:1 hyperutectic pistons. can i just take my new rods and pistons and put them in this block or will it need a rebore to fit the pistons perfectly. i would be replcing .030 over pistons with .030 over forged pistons and scat 4340 rods Wolfplace Mar 7th, 04, 10:55 PM Originally posted by 300hp: i want to get some forged pistons and better rods to put in the 355 but do i need to rebore? its a .030 over 350 w/ fed mogul 9.35:1 hyperutectic pistons. can i just take my new rods and pistons and put them in this block or will it need a rebore to fit the pistons perfectly. i would be replcing .030 over pistons with .030 over forged pistons and scat 4340 rods Not if it was bored properly in the first place. The clearance is built into the piston not the bore. I am assuming this is a good bore & not worn?? 300hp Mar 7th, 04, 11:49 PM yeah, bore had no ridge last summer and has probly 2500 miles since then. so i CAN or CANT do this. Wolfplace Mar 8th, 04, 1:05 AM No Problem, just check the clearance & hone it, as I said, if it was bored properly it should be fine ;) | ||