Using all hard parts from a 1970 Monte to convert front drums to front power disc with 11 inch booster.Porportioning valve is mounted beside master cylinder with aftermarket bracket.The two short curly lines from the master to the valve hooked up fine.
I bought a complete set of stainless lines from inline tube and they appear to end about where the old distribution block was mounted to the frame.these lines are the front to rear long line,the right front and left front line
My question is how or what arrangement is used to get these lines up to the porportioning valve? I was told that the old distribution block is no longer used with this arrangement .
Any insight or help would be appreciated.This is a 1967 SS chevelle.

1: Use the old dist. block- Even with a prop. valve you can use your dist. block. Imo this would be the easiest way. The dist. block is just that, A block that directs fluid where it needs to go.

2: Get tee fittings, couplers, adapters, whatever else you end up needing to get lines to go from the prop. valve to the OE style lines.

Two options , number one being my choice if it were me.