Hello Everyone
I have a simulated 67 chevelle wooden steering wheel. I bought the mounting kit for it.
The black plastic protector has a nub on it. How is this installed. I can't find any kind of grove that it slides in.

Also when I attach the horn cap there doesn't seem to have any give to it to make the horn sound.
Need Help AGAIN
John

spring goes in first, slide retainer on pin ( after cutting to correct legnth) install nail end of pin into cancel cam and twist retainer to lock in place

also horn contact and button don't work together (repro JUNK)

Thanks Jeff
What alternative do I have as far as the horn.

John,
I had the same set up on my 66 when I bought it and it worked fine, I however didn't do the install. My 69 had the aftermarket style sport wheel and the horn didn't work when I bought it, I pulled it apart and had to play with everything to get it to work, cut the pin and spring, even had to stick a small piece of plastic down inside to insulate a constant contact that wasn't suppose to be happening.
I found that it's an assemble and tinker to get it right, as it is ..my horn will blow at the slightest contact, but it works.:thumbsup:
Here's a drawing showing assembly procedure, hope it helps.
http://www.chevelles.com/showroom/data/500/medium/scan0002.gif (javascript:;)

Thanks Seb,
Good to hear from you again. I'll work on the wheel after I try and install the BW ( this try will be #8).
Take Care
John

It's one of those things that is easier to do ... than to explain how to do.:(