I have a 68 console for my 4 speed chevelle.The problem is there is quite a space between the console and the carpet. Is there a hump that fits under the carpet to fit the contour of the console or does padding need to be placed under the carpet ?

I have a 68 console for my 4 speed chevelle.The problem is there is quite a space between the console and the carpet. Is there a hump that fits under the carpet to fit the contour of the console or does padding need to be placed under the carpet ?
there is a mounting hump for the rear of the console and also there is a floor hump made for the console shifter that is configured differently than the non-console floor shift hump:thumbsup:

If your car was a non console car previously, say a bench seat 4 speed or a column shift automatic then as stated previously you will have the smaller hump . I guess you could try building up with padding as that will definately be easier than welding in a new hump.

If your car is an original console rig this is what your 4 speed hump should look like:

http://www.ss396.com/mm5/graphics/00000009/RST-72D.jpg

If it was a non console manual trans floor shift car it would look like this:

http://www.ss396.com/mm5/graphics/00000009/RST-72A.jpg

If it was a floor shift auto car (small hole for shift cable) or column shift car the hump would look like this:

http://www.ss396.com/mm5/graphics/00000007/RFP-1462.jpg


If it wasn't an original console car you'll need these brackets:

http://www.ss396.com/mm5/graphics/00000009/IM-2011.jpg


All the pics are courtesy of our sponsor Ground Up www.ss396.com
If you right click the pics and look at properties the part numbers are the last part of the code: ****.jpg