ok i was comin up with some idears for when i get some extra money in the ol wallet....

trick flow kit that will include

23 degree allum heads 64 CC 195 CC intake runners 1.46" dual valve springs (420 lb. spring rate, .600" max lift)

Hydralic roller cam 246 degree/ 254 degree duration at .050" .558"/.558" lift with 1.5 ratio roller rockers 112 degree lobe seperation

this kit has a complete gasket kit cam heads roller rockers doble time chain pushrods all of that for 1600 bucks

and it says it makes 445 HP and 405 FT. Lbs of torque on a 350 which i have with 9.5 to 1 compresson i have 9 to 1 with 72 cc heads so with the 64 ill make 9.5 to 1 atleast

The question is will i make 445 HP and 405 FT lbs. :confused: :D

WELL.................. :(

That's a mighty big cam. It's not gonna make much low speed torque. Is the rest of your set up safe to 6500RPM? If not, you may want to look at a smaller cam. Just my opinion.