Hello,

I have a quick question related to Starter Solenoids. I purchased a new High Torque starter for my 454 1972 Chevelle.

When I went to go hook up the wiring there are different ends on the new solenoid.

For example here is a picture of the old one :
http://store.summitracing.com/largeimage.asp?part=SUM-G1668S&Prod=Summit+Replacement+Starter+Solenoids&img=sum-g1668s_w.jpg
As you can see it is the standard 1 large and 2 small bolts for the wires to bolt to.

Here is a picture for the new one :
http://store.summitracing.com/largeimage.asp?part=SUM-G1656&Prod=Summit+Replacement+Starter+Solenoids&img=sum-g1656.jpg
On this one there is two larger bolts and a elec type plug.

My question is I'm guessing I need to put new ends on a couple of the wires I have but am not sure which one goes where.

Any help would be greatly appreciated.
Thank you

Any wiring instructions on the new starter? The S terminal on the old one comes from the ignition switch. The R would feed the ignition coil in a points system, not needed with HEI.

The big one is obviously the battery connection.

Take a look at this;


http://i153.photobucket.com/albums/s228/deancall/Team/OLDNNEW_SOLENOID.jpg

WOW. Thank you both very much I am soo pumped to finally get my SS running.