ImpBiscuit
Nov 17th, 04, 9:04 AM
I went back to Dyno last night with my new Mighty Demon 850. What a deference just look at curves. The demon starts and run great. I can idle so smooth it is scary. I can now cruise smooth in 6th gear bellow 2000rpm. I drives like a different car and runs great. If it does not rain I am going to put my M/T ET's 10.5x28 and go to track on Saturday. You can go to my web page link(Webshots)and go to 468 album. There are two graphs there on with Holley and on with Demon.
John graemlins/hurray.gif
onovakind67
Nov 17th, 04, 9:54 AM
How does the air/fuel ratio graph comparison look?
71454Chevelle
Nov 17th, 04, 10:11 AM
John,
What's the specs on your setup (engine, tranny, gears).
518hp to the rear wheels is quite impressive! :eek:
ImpBiscuit
Nov 17th, 04, 7:20 PM
His A/F meater was down. My combo is a 468ci. Steel shaft, H-beam rods.10.7:1CR,Canfield 310's with 113 chambers. a UltraDyne mech roller .251/.260 .630/.630lift,Isky Red Zone,Comp roller rockers, Victor JR, 850Demon, 2" hookers with 3" out the back. It is in a 65 Biscayne with 3.55's and a Richmond 6 speed.
John
kjett
Nov 17th, 04, 7:31 PM
Originally posted by ImpBiscuit:
His A/F meater was down. My combo is a 468ci. Steel shaft, H-beam rods.10.7:1CR,Canfield 310's with 113 chambers. a UltraDyne mech roller .251/.260 .630/.630lift,Isky Red Zone,Comp roller rockers, Victor JR, 850Demon, 2" hookers with 3" out the back. It is in a 65 Biscayne with 3.55's and a Richmond 6 speed.
John graemlins/thumbsup.gif