Sorry sir i tried to post a link to my last thread but no go. I have a 406, fast burn heads, dish forge pistons, gm performance high rise vortec intake, hei, GM roller 1.5 self aligning rockers, Holley 750 hp carb, 1 3/4 headers. My machinist computed the compression to be around 10.25 so i need a cam around the .510 split duration range. I might run small shots of gas around the 100-150 horse mark. Rear gear will be 3.73 with 200r4 with a 2800-3200 stahl. Tires are 295-50 15 radials with a drag radial also. Car is fully dressed 70 camaro, no ac. Is there a voodoo cam around this range? Hydraulic flat or hydraulic roller doesnt matter.

Give me a good thumpy roller grind also. My compression will help a bunch.

anyone?

crane powermax hy roller # 119841 is a nice stick.
234/242 @.050"
112 lsa
.539/.558" lift

will have decent street manners and go well with nitrous. Howards makes one that is the same but with a tad less lift. The howard cam is more than a hundred dollars cheaper.

if you dont run nos use this crane cams grind

222/230 @.050 .509/.528 108° lobe seperation 103° intake centerline hyd roller cam

With nos use this cam on a 112 lobe seperation

Pm and i can get you details on this cam, we deal direct with crane cams

crane powermax hy roller # 119841 is a nice stick.
234/242 @.050"
112 lsa
.539/.558" lift

will have decent street manners and go well with nitrous. Howards makes one that is the same but with a tad less lift. The howard cam is more than a hundred dollars cheaper.
What is howards brand and part number? Will i have to wait on this thing like everybody else? Is there a voodoo part number with similar specs?

Mike,

Pm me for crane

I would run the 108° for an awesome sound and performance and maybe a hair bit bigger after we look over your specs. If your gonna for 100% sure use nos go 112°

My camshaft designer is who just wroth the article in chevy high performance, Mr. Chase Knight, that is my camshaft designer at crane cams

anyone?
=
Mike
Harold's new phone number
(662)562-7400

competition products carries howards stuff.
http://www.competitionproducts.com/products.asp?dept=330

just scroll down, it's on a billet core also. You could call howards up direct and see what they say. But if you want a nasty idle get it on a 108lsa or atleast 110. I dealt with them before and they always gave me spot on advice.

We use a UD Hyd roller in a 406. Bullet Cams can make one for you.
Its 288/296 adv. 234/242 @ .050 .530/.530 on a 108 sep. Compression very close to yours and in a 78 Camaro.
11.40`s @ 119 MPH 1.67 60 ft shifting at 5400-5800 rpm and 3.23 gears if this helps.