jrlars
Dec 29th, 07, 9:37 AM
Quarter panels were replaced about 15 years ago when car was repained; but the anodized aluminum rear rocker moldings that go behind the rear wheels were not replaced.
From looking at the moldings there appears to have been 3 clips screwed into the quarter panels that held the moldings on along with 3 screws on the bottom side. Is there anyway to mount these moldings without drilling holes for the clips and screws? I think 3M 2 sided tape will do the trick on the bottom. But what about the top, any ideas? Thanks.
JIM
From looking at the moldings there appears to have been 3 clips screwed into the quarter panels that held the moldings on along with 3 screws on the bottom side. Is there anyway to mount these moldings without drilling holes for the clips and screws? I think 3M 2 sided tape will do the trick on the bottom. But what about the top, any ideas? Thanks.
JIM