Here are some pics I took this wekend after getting the new hood installed, as well as the carb hat, and E.T radials.

Monday I am putting in the new cam and third member.

G

With Cowl:

http://66283.150m.com/Gene/sidewithcowl.jpg

From the side:

http://66283.150m.com/Gene/sidewithcowl2.jpg

295/65/15 E.T Radials

http://66283.150m.com/Gene/tirefit.jpg

Engine

http://66283.150m.com/Gene/top.jpg

Looking good. Pretty sure I am taking the turbo plunge this summer. Start off small with a Holset HX35 on 305. Where's the carb hat from?

Thanks
Steve

Thanks for the kind words. The carb hat is from Extreme Velocity. I added the 1" spacer to the bottom so the hat would clear my float bowls.. Their site is www.superiorairflow.com (http://www.superiorairflow.com)

Looks great!! I'd like to know some HP numbers on the turbo setup once you get them!!

Thanks!!

Looks good.

Do you think the set up would have fit under a 2" cowl hood?

Thinking of doing Turbos on mine in the distant future.

It would have easily fit under a 2". I had it under a stock hood prior to the cowl. I went to 6" for something to grow into;)

G

Bob, looks good. are you running a single exh, or 1 into 2?

Right now there is a 4" downpipe that goes under the motor beside the oil filter into a bullet muffler. then directly after the muffler I used an old kenworth 5" stack (the kind with the 45 at the top) it fit right over the muffler and stays with a band clamp.. (that sends the noise out back) It all clears quite well

Sounds good, keep us posted,look forward to more pics.