check this car out and tell me if you think its worth $15,000 ebay number 180188347346 i hit him with an offer of 12 but he says 15 is the number he wants. good bad or otherwise?

http://cgi.ebay.com/ebaymotors/1970-CHEVELLE-V8-CONVERTIBLE-ALL-ORIGINAL-LOW-MILES-55K_W0QQitemZ180188347346QQcmdZViewItem?hash=item1 80188347346

You better go look at it just to make sure its not all covered up with bondo.
You live close better get over their tomorrow since you are in the same area:yes:

Looks great! I wish mine was a vert. 20,000 seems a bit high though.

after looking at the slide shows all I see it needs are doors, full quarters and fenders, but thats all that was in the slide show ;)

that';s a pretty penny for that car. Might be worth it if it's all original like he says.

after looking at the slide shows all I see it needs are doors, full quarters and fenders, but thats all that was in the slide show ;)


That's what I was thinking and if there bad I'll bet the trunk and floor are too.!!! He was going to clone it until he really looked at it. New Jersey winters can you say SALT!

Looks like one of the body panels was replaced with the wrong panel.
With the amount of rust showing, you can bet the trunk and floors need to be replaced.

He admits the carpet needs replacing but he didn't show it. Usually a reason.

That car is going to need a ton of work. Without seeing more pics of the interior, floors and trunk, it is hard to put a dollar value on it.

Overpriced.... I only paid $500 for mine :).

Overpriced.... I only paid $500 for mine :).Which peice Tom, LOL

Overpriced.... I only paid $500 for mine :).

http://www.chevelles.com/showroom/data/500/P1010232.JPG looks like it needs less sheet metal than the ebay car

The floors in mine are toast, both cab section and trunk. The doors and fenders on mine are fixable, but I'm just going to get new ones instead...less bodywork :).

Brad,

I've been collecting all the parts I need for the vert over the last couple years. I paid almost as much for the transmission I'm going to use than I did for the rolling sheel of a car I have...kinda scary. I am, however, proud to say I've acquired them all except the rest of the sheetmetal I need :). Just a matter of me doing it now, lol.