I am putting a 327 into my 1967 Chevelle where a 283 used to be. I thought I would use the same PS brackets and the same ALT brackets but when I look at them closer I find someone has made pieces to make them fit. I would like to know what it looks like when done correctly, (if someone could post a picture). I also would like to know where to purchase these brackets. As a little extra to make this harder I have headers instead of stock exhaust manifold. Can someone HELP?

This may help.


http://i152.photobucket.com/albums/s182/y72ss/100_0510.jpg

Most of the header mfgs sell the brackets. Oh, and nice engine pic...............

There is a guy, J.N.V. Specialty Componants who makes every conceivable braket, nicely made I think its lazer cut steel sold bolts, spacers, instructions etc, not platted, not billit aluminum. Probubly what the header companies are selling, or you want to mount a Sanden air compressor on you 350 or 454, no problem. no web site, only sells thru Ebay, I just purchased Low right side alternator bracket, and Sanden air brackets for my 454 for abt $160.
I have for sale his mount for Sanden compressor on left side of small block

geat picture George need info on what type of intake on your engine,thermostat housing and upper hose. great work on the engine.

geat picture George need info on what type of intake on your engine,thermostat housing and upper hose. great work on the engine.

Thanks,
The intake is a Edelbrock Performer. Thermostat housing and upper hose is stock '67 stuff.

Try this http://www.alangrovecomponents.com/

Mr. Gasket has the 2-piece header alternator bracket that you need.

George: Very nice! That looks alot like mine will when I am finished. I don't know if you can but a picture from the underside where I can see the mounting bracket and the adjustment bracket for the power steering res. would sure help me a lot.

I used Alan Grove brackets as stated above, nice stuff.
http://memimage.cardomain.net/member_images/6/web/2190000-2190999/2190215_62_full.jpg