A few years back in one of the magazines in the back there was a place you could get plans for a test stand it had gauges and a radiator I know they can be purchased complete but I have access to welding equipment and prefer to build my own Thanks Mike

mike, the one i've seen was a engine cradle with a bracket for radiator, gas tank and battery. shouldnt be too hard to fab up, just use a dummy block as a jig so you get the motor mounts right.

Mike,
We have a "store bought" run in stand that works pretty good. I will try to take a picture or two of it and send them to you. It may take me a while as I just started a new roll of film in the camera, so be patient.
BillK

------------------
Bill Koustenis
Advanced Automotive Machine
Waldorf Md