as a machinist for 10 years and a car guy both go hand in and. i want to install some injector bungs on my intake but not sure how close they should be to the intake runner. as doing some research i fould out they should be about 1 inch up and center of the runner. was wondering if anyone knows where i can get more information or if someone has installed them. thanks

Larry,
Go over to the Camaro page and put a post on the EFI forum. I am pretty sure Doug Flynn from Holley is a regular there and could probably answer your question.

You should also watch your fuel rail spacing, if you have a pre-machined fuel rail. If you're machining your own fuel rail, you'll want to transfer the bung centers to the rail, and also keep the bungs consistent in height. What are you building?