I have a small ding in my left rear quarter pannel right above the body seam/crease that runs along the length of the car. Its located about 7 inches behind the back edge of the drivers door right below the quarter window. I was told I could access this part of the quarter pannel by removing the rear seat and interior side pannel. Has anyone done this before..

Thanks....

yeah, you'll also have to remove the quarter window assembly and glass, I think. It's pretty tight back there....

....sounds like a good "PDR" candidate to me....Don`t `69s have a vent in the jamb area ? A pdr guy, or you, could access this dent from there by removing the vent. Right ?

Definitely bump it out through the vent if you can get around the window mechanism. It's a lot of work pulling the interior and glass and the access won't be much better from the inside than through the vent.

Tom

I have a 1966 post sedan, there is no vent on the inside of the quater jam, thats the way the car was when I bought it. Maybe there is suppossed to be a vent ?????

...ahhhhh...a `66.....I could have sworn I saw "69" at your initial post........`66? No vent.