Did I see you mention you are working on some small solid SBC cams? Have any specs for us yet? Lastly, will these be a catlog item by next summer (I won't be doing anything until then). Thanks!

BTW... my application is a 9.25:1 327 in a Chevy II w/ 160cc heads (2.02/1.60)... looking for a nice flat torque curve in the 3000-5000 range. Peak HP @ around 5500.

I'm also waiting for Lunati's new line of SBC mechanical lifter cams that I heard were coming out. I'm itching to buy smile.gif Hopefully sooner than next summer.

Anxiously awaiting Harolds response.

TTT, maybe Harold missed this

Officially, about December 1st.....
At PRI, unless they decide SEMA instead.
It's Holley's choice.
You all will like them.

UDHarold

The only VooDoos I've seen are hydraulic.
Are the solids not as well advertised,
or not available yet?

Cheers,
mark.
383...

The solid VooDoos I took to Bowling Green in August, 2004, have not been tested yet.
There will be a new catalog out before SEMA, so the solid VooDoo mechanical and roller cams with have to be in the SEMA/PRI supplement.....

UDHarold