Do I install my bushings loose side of arm to tight side or tight side to loose side?
Same question in a different way: should the bushing be difficult to get in the hole or should I be able to slide about 2/3 of the bushing through then have it get difficult?

------------------
Mike
formerly known as gotapileof70Malibu
'70 Malibu
'70 Malibu convertible



[This message has been edited by RagTop70 (edited 08-23-99).]

The bushings should have a stepped diameter. That is the diameter near the flange is a little larger than the non-flanged end.And the holes in the arm are different diameters, too. Put the non-flanged end of the bushing into the larger hole and it will go in most of the way, with the last 1/4 inch being a press fit.

Thank you very much.

------------------
Mike
formerly known as gotapileof70Malibu
'70 Malibu
'70 Malibu convertible