|
Big Dre 72 Dec 24th, 04, 12:02 AM I have a set of camel hump heads w/ 186 casting number.According to www.mortec.com (http://www.mortec.com) these are off a 69-70 Camaro.They come w/ accessory holes.My question is,What kind of motor could I build for a daily driver with an occasional run down the strip? These are 64cc heads.Thanks guys! graemlins/beers.gif RB69SS396Conv Dec 24th, 04, 12:18 AM What kind of motor could I buildA small block Most any motor with CID and pistons such that a reasonable CR was produced with those chambers, and a cam that matches their flow characteristics. They came from the factory on 302s and 350s. I've run them on those, plus 283s, 327s, and 400s; with good success. Thsy are about ideal for a moderate street 350 with flat-top pistons and a zero-decked block. With an appropriate cam (225° intake, 6-10° more exhaust, .500ish lift) you can expect 350-360 HP easily; more if you do a first-rate port job on them. Big Dre 72 Dec 24th, 04, 12:28 AM Thanks RB. What c/r do you think with some flat-top pistons and zero decked? graemlins/thumbsup.gif Wolfplace Dec 24th, 04, 12:33 AM Originally posted by Big Dre 72: Thanks RB. What c/r do you think with some flat-top pistons and zero decked? graemlins/thumbsup.gif = Any particular size engine :D Big Dre 72 Dec 24th, 04, 12:36 AM I was thinking of a 350 or 400! Wolfplace Dec 24th, 04, 1:58 AM Originally posted by Big Dre 72: I was thinking of a 350 or 400! About 10.2 with a 350 & a .039 gasket, too much on a 400 :D ,,, About 11.6 Big Dre 72 Dec 24th, 04, 2:30 AM Any suggestions on a specific combo? Thanks,Wolfplace. | ||