I ordered the complete Dick Miller 4-link kit for my 67 drag car, complete with the antiroll bar as well. I've got the control arms, no-hop bars, and new QA1 shocks installed, but am running into a bit of a blank here. This kit includes triangulation braces and I know it sounds stupid but I can't figure out where they go?! Any help here?

Also, I'm having a bit of trouble figuring out where I should mount the control arm diagonal braces, and really can't envision how the anti-rollbar will mount to the rest of this. Does anybody have any pictures of a car with the kit installed for reference? Or a diagram or such? Thanks!

I ordered the complete Dick Miller 4-link kit for my 67 drag car, complete with the antiroll bar as well. I've got the control arms, no-hop bars, and new QA1 shocks installed, but am running into a bit of a blank here. This kit includes triangulation braces and I know it sounds stupid but I can't figure out where they go?! Any help here?

Also, I'm having a bit of trouble figuring out where I should mount the control arm diagonal braces, and really can't envision how the anti-rollbar will mount to the rest of this. Does anybody have any pictures of a car with the kit installed for reference? Or a diagram or such? Thanks!

I assume they are similar to the stock triangulation braces. If so, they tie into the front bolt of the upper control arm on the opposite side of the rear crossmember on one end, the other end tie into the front bolt of the lower crossmember.

HTH....

I assume they are similar to the stock triangulation braces. If so, they tie into the front bolt of the upper control arm on the opposite side of the rear crossmember on one end, the other end tie into the front bolt of the lower crossmember.

HTH....

That should say lower CONTROL ARM

OK, so I'm reading this to mean they go from the front bolt on the upper control arm to the front bolt on the lower control arm then? That looks like it'd fit....

OK, so I'm reading this to mean they go from the front bolt on the upper control arm to the front bolt on the lower control arm then? That looks like it'd fit....

Yes, that's correct Rich. Sorry for the typo and good luck :thumbsup:

OK, so I'm reading this to mean they go from the front bolt on the upper control arm to the front bolt on the lower control arm then? That looks like it'd fit.... Didn't Dick Miller send any instructions with these pieces? You might call him and have him clarify the instructions. I found the gentleman kinda hard to talk to.

It also sounds like you got his new lowers with the triangle bars that tie from the lowers to the rear end housing as well.His stuff is top notch. I run his rear springs and anti roll bar. Go to maliburacing.com and go to forum and look up suspension. Lots of pics in thier of the install of anti roll bar. Did you get the one that goes through the coil?

http://img209.imageshack.us/img209/2377/dmr70281fk4.th.jpg (http://img209.imageshack.us/my.php?image=dmr70281fk4.jpg)



FYI

Pete